Hydro Jetting in Lakewood

Lakewood's housing stock and the pipe beneath it

Lakewood was mostly finished before the Great Depression. The streets between Detroit Avenue and Clifton Boulevard, the doubles along Madison Avenue, and the brick apartment blocks near the Gold Coast all went in between 1900 and 1930. That means the sewer laterals are vitrified clay in short lengths with mortar or tar joints, connected inside the foundation to cast-iron drain piping that has had a hundred years to corrode.

Lots are narrow, often forty feet or less, so the lateral usually runs under the driveway or a side-yard walk to reach the street. Many houses share a driveway with the neighbor, and a surprising number of laterals cross a corner of the adjacent lot before turning toward the main. Lakewood has almost no PVC laterals, because there was almost no building after PVC became standard, except for the occasional infill house or a lateral replaced after a collapse.

Combined sewers, clay soil, and old trees

Lakewood is one of the Cuyahoga County communities with a combined sewer system, where sanitary flow and storm runoff share the same pipes. In a hard summer thunderstorm the mains fill, and a basement with a floor drain and no backwater valve can take on water that is not just rain. Lakewood runs its own treatment plant on the lakefront and has spent years separating sewers and adding storage, but the older cores still see surcharge.

The ground under the city is lake-plain clay over shale, with a water table that rises close to the surface near the lake and along Rocky River. Saturated clay pushes on a pipe from the outside while frost heave, down to roughly three feet, lifts the shallow end near the house each winter. A century of that leaves joints open. Lakewood's tree canopy is one of the densest in the county, and the sycamores, silver maples, and Norway maples lining the streets send roots straight into those openings.

Choosing between lining and bursting on a narrow lot

Lining is the default in Lakewood because excavation is so costly on a tight lot. After a camera inspection and a thorough hydro jetting to strip the roots, the installer inverts an epoxy-saturated felt liner from the basement cleanout, cures it with hot water or steam, and cuts open any branch connections with a robotic cutter. The result is a jointless pipe inside the old clay, and nothing above ground has moved.

Pipe bursting still has a place when the camera shows a crushed section, a joint offset so badly the camera cannot pass, or a belly deep enough to hold standing water. Bursting needs a pit at each end, and on a Lakewood lot one of those pits may land in a shared driveway, so the installer should walk the route with you first. For a single cracked bell in an otherwise sound line, a sectional point repair saves lining the whole run.

Permits in Lakewood and the sidewalk boundary

Lakewood issues sewer and plumbing permits through its building department, and an inspector will want to see the camera video before and after a lining job or the open trench at a bursting pit before backfill. Work that disturbs the tree lawn, sidewalk, or street needs a separate right-of-way permit. Because Lakewood's sewers flow into Lakewood's own plant rather than the regional district's, the city's own sewer regulations govern connections, though NEORSD rules may apply at the regional boundary.

Check who is responsible for the stub between the sidewalk and the main. In most communities around Cleveland it is the property owner, and a contractor who works Lakewood weekly will know the current rule and whether the city will inspect that section.

On the day, and how to find the right crew

A Lakewood lining job usually starts early. The crew jets the line, films it, measures the run, and saturates the liner on the truck. The cure takes a few hours, then the reinstatement cuts, a final video, and a quick cleanup. Most homes have drains back by dinner. Bursting takes a day for the pull and another for restoring the pits, and shared driveways get a steel plate overnight if needed.

Ask every bidder for the camera footage, the exact footage of pipe to be lined, and the liner thickness. To compare contractors who have verified training and insurance, find a verified CIPP contractor and request a recent Lakewood reference. A crew that has worked these narrow lots will have an answer for the driveway question before you ask it.

Hydro Jetting in Lakewood

What a jetter does that a cable cannot

A hydro jetter pushes water through a nozzle at several thousand PSI. Rear-facing jets pull the hose down the line and scour everything off the pipe wall: roots, grease, sludge, mineral scale, and the rust flakes inside old cast iron. A cable machine drills a hole through the blockage and leaves the rest on the wall, which is why cabled lines re-clog on a schedule.

Where it fits in a repair

Jetting is step one before lining, because a liner has to bond to clean pipe, and step one before an honest camera inspection, because a line full of roots or scale hides its own condition. It is also legitimate maintenance on its own for a structurally sound line that roots keep finding.

When a line should not be jetted

Cast iron that is paper-thin at the bottom can be opened up by an aggressive descaling pass. A collapsed clay section will not let the hose through. Orangeburg can delaminate under pressure. An experienced operator checks the line first, matches the nozzle to the material, and stops if the pipe is not holding up.

Maintenance versus repair

If the camera shows sound pipe, annual or semiannual jetting is a cheap way to stay ahead of roots. If it shows open joints, channeled cast iron or offsets, jetting is a stopgap and the money is better spent on lining, which removes the joints the roots are using.

ZIP codes served in Lakewood

Hydro Jetting is available throughout Lakewood, including ZIP codes 44107.

More trenchless services in Lakewood

Questions we hear in Lakewood