Sectional Point Repair in Lakewood

Lakewood's housing stock and the pipe beneath it

Lakewood was mostly finished before the Great Depression. The streets between Detroit Avenue and Clifton Boulevard, the doubles along Madison Avenue, and the brick apartment blocks near the Gold Coast all went in between 1900 and 1930. That means the sewer laterals are vitrified clay in short lengths with mortar or tar joints, connected inside the foundation to cast-iron drain piping that has had a hundred years to corrode.

Lots are narrow, often forty feet or less, so the lateral usually runs under the driveway or a side-yard walk to reach the street. Many houses share a driveway with the neighbor, and a surprising number of laterals cross a corner of the adjacent lot before turning toward the main. Lakewood has almost no PVC laterals, because there was almost no building after PVC became standard, except for the occasional infill house or a lateral replaced after a collapse.

Combined sewers, clay soil, and old trees

Lakewood is one of the Cuyahoga County communities with a combined sewer system, where sanitary flow and storm runoff share the same pipes. In a hard summer thunderstorm the mains fill, and a basement with a floor drain and no backwater valve can take on water that is not just rain. Lakewood runs its own treatment plant on the lakefront and has spent years separating sewers and adding storage, but the older cores still see surcharge.

The ground under the city is lake-plain clay over shale, with a water table that rises close to the surface near the lake and along Rocky River. Saturated clay pushes on a pipe from the outside while frost heave, down to roughly three feet, lifts the shallow end near the house each winter. A century of that leaves joints open. Lakewood's tree canopy is one of the densest in the county, and the sycamores, silver maples, and Norway maples lining the streets send roots straight into those openings.

Choosing between lining and bursting on a narrow lot

Lining is the default in Lakewood because excavation is so costly on a tight lot. After a camera inspection and a thorough hydro jetting to strip the roots, the installer inverts an epoxy-saturated felt liner from the basement cleanout, cures it with hot water or steam, and cuts open any branch connections with a robotic cutter. The result is a jointless pipe inside the old clay, and nothing above ground has moved.

Pipe bursting still has a place when the camera shows a crushed section, a joint offset so badly the camera cannot pass, or a belly deep enough to hold standing water. Bursting needs a pit at each end, and on a Lakewood lot one of those pits may land in a shared driveway, so the installer should walk the route with you first. For a single cracked bell in an otherwise sound line, a sectional point repair saves lining the whole run.

Permits in Lakewood and the sidewalk boundary

Lakewood issues sewer and plumbing permits through its building department, and an inspector will want to see the camera video before and after a lining job or the open trench at a bursting pit before backfill. Work that disturbs the tree lawn, sidewalk, or street needs a separate right-of-way permit. Because Lakewood's sewers flow into Lakewood's own plant rather than the regional district's, the city's own sewer regulations govern connections, though NEORSD rules may apply at the regional boundary.

Check who is responsible for the stub between the sidewalk and the main. In most communities around Cleveland it is the property owner, and a contractor who works Lakewood weekly will know the current rule and whether the city will inspect that section.

On the day, and how to find the right crew

A Lakewood lining job usually starts early. The crew jets the line, films it, measures the run, and saturates the liner on the truck. The cure takes a few hours, then the reinstatement cuts, a final video, and a quick cleanup. Most homes have drains back by dinner. Bursting takes a day for the pull and another for restoring the pits, and shared driveways get a steel plate overnight if needed.

Ask every bidder for the camera footage, the exact footage of pipe to be lined, and the liner thickness. To compare contractors who have verified training and insurance, find a verified CIPP contractor and request a recent Lakewood reference. A crew that has worked these narrow lots will have an answer for the driveway question before you ask it.

Sectional Point Repair in Lakewood

Fix the spot, not the line

A sectional point repair treats a short length of pipe, usually two to six feet, instead of the whole lateral. A short fiberglass or felt liner saturated with resin is positioned over the defect on an inflatable packer, pressed against the wall, and cured in place. The rest of the line is untouched. Where the defect cannot be lined, the alternative is a small excavation at that exact spot, made possible because the camera and locator have already marked it to within inches.

When it makes sense

One identifiable defect, or two or three close together, on a line whose remaining footage is sound: a joint crushed when a driveway was poured over it, a single root-intruded joint under a parkway tree, a break where the lateral crosses another utility trench, or the transition where under-slab cast iron meets the clay or ABS running to the street.

When it does not

If the camera shows the same defect at every joint, or channeling along the whole bottom of a cast iron line, fixing one spot moves the next backup a few feet down the pipe. A full liner costs more today and far less over the next few years.

A fair test

Ask to see footage of the pipe on both sides of the proposed repair. If it is clean for the full run, a point repair is honest and economical. If it is not, ask why a full liner was not proposed.

ZIP codes served in Lakewood

Sectional Point Repair is available throughout Lakewood, including ZIP codes 44107.

More trenchless services in Lakewood

Questions we hear in Lakewood